Direct Supply® Insulated Holding and Proofing Cabinet, Full Size, Universal Slide

Construction:

• 20-gauge aluminum frame construction
• Magnetic door latch keeps door securely closed
• Hinged door has a 180 degree swing
• Door-mounted gasket to keep heat inside of chamber
• Water pan located at bottom of cabinet
• 5” swivel casters (2 front casters are locking)
• 1” Non-marking rubber bumper wraps around bottom and prevents scratching shell

Racks

• Removable wire slides for easy cleaning of cabinet interior
• Ends of rack posts must be in place to meet NSF sanitation standards (post holes must be fully sealed when racks are in place. Rack posts have removable caps to allow for cleaning)
• Universal slides are adjustable in 1.5” increments
• Includes 18 slide pairs

Heat Unit Specifications:

• Rated Power: 1500W, 120V, 20 amps, 60 Hz
• Temperature Range: 80° – 185°F
• Humidity Range: 30% – 100%
• Voltage: 120 Volts
• Wattage: 2,000 Watts
• 7.5ft cord with a NEMA 5-20P plug

Controls

• Digital thermometer for easing readings
Independent analog controls allow you to set the temperature and humidity inside the cabinet for optimal holding or proofing conditions

Heat Settings

Heat Mode should be used when a holding temperature above 100ºF is desired. The cabinets temperature range is 80ºF to 185ºF. The dial numbers, 1 through 9, do not relate to a specific calibrated temperature. Temperature settings should be monitored via the temperature display.

To maintain temperatures between 85ºF and 100ºF, move the switch to proof mode and adjust heat knob to until the desired temperature is reached. Allow 45 minutes to pre-heat in proof mode.

Humidity Settings

•To control humidity range from 30% to 100%, make sure there is water in the pan in the bottom of the unit. Use the dial numbers, 1 through 9, to achieve the desired humidity level. The numbers do not relate to a specific calibrated humidity, A hygrometer can be used to determine the setting needed to maintain the desired level of humidity.